Spinal Cord Stimulation (Paddle Lead, Medtronic)

OVERVIEW

Spinal cord stimulation (also called SCS) uses electrical impulses to relieve chronic pain of the back, arms and legs. It is believed that electrical pulses prevent pain signals from being received by the brain. SCS candidates include people who suffer from neuropathic pain and for whom conservative treatments have failed.

SCREENING TEST IMPLANTATION

The injection site is anesthetized. One or more insulated wire leads are inserted through an epidural needle or through a small incision into the space surrounding the spinal cord, called the epidural space.

FIND THE RIGHT LOCATION

Electrodes at the end of the lead produce electrical pulses that stimulate the nerves, blocking pain signals. The patient gives feedback to help the physician determine where to place the stimulators to best block the patient’s pain. The leads are connected to an external trial stimulator, which will be used for approximately one week to determine if SCS will help the patient.

DETERMINE EFFECTIVENESS

If the patient and physician determine that the amount of pain relief is acceptable, the system may be permanently implanted. At the end of the trial implantation, the leads are removed.

PERMANENT IMPLANTATION

The permanent implantation may be performed while the patient is under sedation or general anesthesia. A small incision is made in the lower back so that the surgeon can access the lamina, the bone that protects the nerve roots and spinal cord.

REMOVING THE LAMINA

The surgeon removes a portion of the lamina. This will make space for insertion of the permanent lead.

INSERTING THE LEAD

The paddle lead is passed through the opening in the lamina and into the epidural space. The surgeon confirms correct placement of the lead through the use of an x-ray device called a fluoroscope.

DEVICE IMPLANTATION

Next, a small incision is created, and the implantable pulse generator (IPG) battery is positioned beneath the skin. It is most often implanted in the buttocks or the abdomen. The leads are then connected to the IPG battery.

END OF PROCEDURE

The implant’s electrical pulses are programmed with an external wireless programmer. The patient can use the programmer to turn the system on or off, adjust the stimulation power level and switch between different programs.

AFTER SPINAL CORD STIMULATOR IMPLANTATION

After surgery, patients may experience mild discomfort and swelling at the incision sites for several days.